Maintenance

Added Pingelcock - read properly and you'll be happy....

Addition of pingelcock - read properly and you will be happy. 1/4 of a Pingel is 13.5mm. Please select a 1/4 size Pingel cock to use on the CBX1000 without modification. Since it is a forced opening/closing type with a normal cock,there is no need to force replacement. However,it's cool.

2022.04.20

カテゴリ

タグ

Creating a turn signal position lamp on/off for a Honda motorcycle...

CBX1000 turn signal position on/off tuning. By cutting Br/W coming out from 8p (8-pole coupler),on/off function can be realized. The same goes for CB900F. When installing the FCR,a thin switch is installed on the right side. I achieved this by using a 4-pole relay to interrupt the wiring.

2022.04.19

カテゴリ

タグ

FCR-SJ Slow Jet – FCR Carburetor Installation...

I will mainly post photos of the FCR being removed and installed. I adjusted the throttle wire, accelerator pump, and idle stop screw.

2022.04.17

カテゴリ

タグ

FCR-Changed SJ slow jet. 2022-04-15...

Even if I turn only one CBX1000 FCR pilot screw,there is no change in idle. Is it way out of range? Is it a characteristic that we don't notice even though it is changing? I'm not really sure.

2022.04.15

カテゴリ

タグ

FCR-Install SEP bearing guide on CBX1000!...

The CBX1000 FCR has been used for about 20 years. In terms of mileage,I have used it less than 10,000 km,and I use it while replacing rubber parts,packing,Vacuum release plate,etc.

2022.04.15

カテゴリ

タグ

Brembo CNC brake caliper installation...

Up front are Brembo CNC axial 2-block calipers titanium hard anodized 40mm. At the back is a Brembo CNC axial 2 block caliper with hard anodized new crab 82mm.

2022.04.14

カテゴリ

タグ

Replace the exterior with a repainted one...

The exterior is primarily red, with gold and orange lines. There are two types of lines, so be mindful of the details.

2022.04.14

カテゴリ

タグ

Install Quick turn throttle -Active Type3...

Changed the throttle holder from Vito to Active. It went from 90 degrees to 56 degrees. When the accelerator opening is 90 degrees,it is low throttle.

2022.04.13

カテゴリ

タグ

table comstar wheel Polished manual work...

table comstar wheel Polished manual work.From removing the anodized aluminum to the rim and spokes. I can go 200km/h and I went to the circuit. No trouble.

2022.04.13

カテゴリ

タグ

A Story About a Vehicle Inspection: Speedometer Failed Four Times...

I went for a CBX1000 user vehicle inspection for the first time in a while. I could have asked the motorcycle shop where I usually leave it, but they seemed busy. I wanted to work on my motorcycle myself.

2022.04.12

カテゴリ

タグ