I am writing articles related to CBX1000. The basics are the same whether it's a 6 cylinder or a 4 cylinder! Should be. . .

Creating a turn signal position lamp on/off for a Honda motorcycle...

CBX1000 turn signal position on/off tuning. By cutting Br/W coming out from 8p (8-pole coupler),on/off function can be realized. The same goes for CB900F. When installing the FCR,a thin switch is installed on the right side. I achieved this by using a 4-pole relay to interrupt the wiring.

2022-04-19

カテゴリ

タグ

HONDA CBX1000 Photos 2022-April...

I write explanations and concepts about motorcycles. Basically,there are almost no parts that are not touched. The frame is a little old but has been repainted. The engine has had the paint removed and is in pristine condition. I'm installing Brembo,Ohlins,Dangani,FCR,Uotani,etc. My main tires at the moment are Continentals.

2022-04-18

カテゴリ

タグ

FCR test run,Yasuno Station...

Let's go for a test run after tuning up the FCR! Yasuno Station in northern Hiroshima Prefecture is becoming a secret touring spot,and the number of people is increasing every year. There were a lot of people on bicycles,and I saw people with Shimane license plates here and there. I rarely use it when I want to go for a long test run.

2022-04-18

カテゴリ

タグ

FCR-SJ Slow Jet – FCR Carburetor Installation...

I will mainly post photos of the FCR being removed and installed. I adjusted the throttle wire, accelerator pump, and idle stop screw.

2022-04-17

カテゴリ

タグ

FCR-Changed SJ slow jet. 2022-04-15...

Even if I turn only one CBX1000 FCR pilot screw,there is no change in idle. Is it way out of range? Is it a characteristic that we don't notice even though it is changing? I'm not really sure.

2022-04-15

カテゴリ

タグ

FCR-Install SEP bearing guide on CBX1000!...

The CBX1000 FCR has been used for about 20 years. In terms of mileage,I have used it less than 10,000 km,and I use it while replacing rubber parts,packing,Vacuum release plate,etc.

2022-04-15

カテゴリ

タグ

CBX1000 Photos - At Personal Garage - Many Photos...

This is a photo gallery of Personal Garage. This is a fun garage with everything from normal to shiny road glides. Next door is a custom car shop.

2022-04-14

カテゴリ

タグ

Brembo CNC brake caliper installation...

Up front are Brembo CNC axial 2-block calipers titanium hard anodized 40mm. At the back is a Brembo CNC axial 2 block caliper with hard anodized new crab 82mm.

2022-04-14

カテゴリ

タグ

Replace the exterior with a repainted one...

The exterior is primarily red, with gold and orange lines. There are two types of lines, so be mindful of the details.

2022-04-14

カテゴリ

タグ

Install Quick turn throttle -Active Type3...

Changed the throttle holder from Vito to Active. It went from 90 degrees to 56 degrees. When the accelerator opening is 90 degrees,it is low throttle.

2022-04-13

カテゴリ

タグ