2022-09

Cowl

Repaint - The illustration I provided when requesting the repaint....

I organized my Google Drive. I found an illustration for the instructions I wrote when I requested the exterior repaint of my CBX1000. I will write about it. I will hire a repaint professional to do the job. Professionals fulfill client orders while conducting interviews.
       
カテゴリCBX1000CowlMaintenance
タグCBX1000ColumnCustomRepaint
FCR

Adjust the balance of the multi-vacuum gauge...

CBX1000 is a 6-cylinder multi-engine. You will need to synchronize the carburetor. The other day,I adjusted the balance of the vacuum gauge for the first time in a while. This time we'll be talking about multi-vacuum gauges for motorcycles. I don't know if it's for cars. Balance adjustment is to align the needles of each meter of the vacuum gauge uniformly. Whether or not the actual negative pressure can be measured accurately is another matter.
       
カテゴリCBX1000FCRMaintenance
タグCBX1000FCRsynchronizationVacuumgauge
FCR

FCR Tuning - Test Run - Adjust AS - 2022-09-29...

I did a test run on the mountain road from 5pm. I changed my SJ the other day. The AS adjustment,PS adjustment,and idling adjustment will be done the next day,so I'll check the startability when it's cold. Since the SJ is being changed from 42 to 40,the plan is to open and close AS and PS about half a turn.
       
カテゴリCBX1000FCR
タグASCBX1000FCRFCR-BeginnersPS
FCR

FCR Tuning - Changed SJ from 38 to 40. PS pilot screw adjustment - 2022-09-28...

① Set the AS to a slightly richer position. ② Set the PS back by 1.00 minutes. ③ Open the PS for about 15 minutes at a time. ④ Open the PS to a point where it is easy to maintain idling and it is finished. In the case of CBX1000,I have never had a problem with driving because the PS was opened too much and it was too rich,but I start from a lean PS and then richen it.
       
カテゴリCBX1000FCR
タグASCBX1000FCRFCR-BeginnersPSSJ
FCR

Since I changed the FCR - SJ, I checked the startability and touched the PS - 2022-09-28...

There are various resets to ensure a comfortable ride. Generally,after changing the SJ,there are many work items as it involves attaching and detaching the cab. ① Adjust the tension of the throttle wire. ②Adjust the PS so that the engine can start. ③Temporarily adjust AS. ④Adjust the idling. ⑤Synchronize. ⑥Take a test run and adjust AS. Adjust the above by going forward and backward through steps 1-6.
       
カテゴリCBX1000FCR
タグASCBX1000FCRFCR-BeginnersJNPSsynchronization
FCR

FCR tuning - Change and synchronize SJ and MJ - 2022-09-27...

About MJ main jet. When I looked at the air-fuel ratio meter,I noticed that it would be better if I made it even slightly lighter. It may not make much sense,but I changed MJ by one step from 128 to 125. This is the season when fuel becomes richer as we approach winter. There is no problem even if you shake it a little thin.
       
カテゴリCBX1000FCRMaintenance
タグASCBX1000FCRFCR-BeginnersMJPSSJsynchronizationVacuumgauge
FCR

FCR - Test run on the expressway - Check the condition of the main jet...

The speed is within the legal speed limit. Fully open the throttle while looking at the gears like 3rd,4th,and 5th. CBX1000 is a motorcycle with up to 5 speeds. 3rd and 4th gears provide peaky acceleration. When you shift to 5th gear,it won't accelerate comfortably until you get up to a certain speed,but it feels like it will gradually increase the top speed and accelerate.
       
カテゴリCBX1000FCRtouring
タグASCBX1000FCRMJ
FCR

Do not set FCR - strictly prohibited before touring....

The weight of troubleshooting is completely different when you drive with the expectation that trouble will occur in your local area,and when you go far and cause trouble. Basically,no matter what kind of work you do,whether it's changing a tire or anything else,replacing something means that your car will go from being running well to not being able to run,even temporarily. Maintenance is about changing your body from a state where you can't run to a state where you can run better than before,or a state where your endurance is higher than before.
       
カテゴリCBX1000FCRMaintenance
タグASCBX1000FCRJNMJPS
Cowl

3 things I liked about CBX1000 with cowl specification...

The best thing about installing the cowl is the change in driving.I have written that there are three things,but the change in driving is the most important and main thing.I also had a lot of fun chatting with riders who like cowls.
       
カテゴリCBX1000Cowl
タグCBX1000CBX400FColumn
FCR

FCR tuning - Considering the seasons of summer and winter when touching AS and PS - 2022-09-17...

Adjustment of AS air screw. I haven't touched FCR for a while,so I need to be a little more conscious of the end of summer and the beginning of autumn. What is especially good about SJ? What level of AS is appropriate? I hope I can find it on my own.
       
カテゴリCBX1000FCR
タグASCBX1000FCRFCR-BeginnersPS