2022-12

FCR

FCR Tuning - Look at the air-fuel ratio during acceleration, not partial...

Looking back on this year, there are some things I pay attention to when setting up the CBX1000 FCR that I didn't do in 2021. I try not to look at the air-fuel ratio when in partial. Partial means a stable riding state with the throttle fixed. The following post is written under the assumption that an air-fuel ratio meter is installed.
       
カテゴリCBX1000FCR
タグCBX1000ColumnFCRFCR-Beginners
FCR

FCR Tuning - The tuning of the BITO is excellent when shipped!...

This is about the presetting of the FCR of the CBX1000. I called BITO to inquire about a custom order for a JN for the FCR. When I ordered the JN about half a year ago, they told me about the initial settings of the FCR. *Please note that the truth of what is written on the Internet is not certain.
       
カテゴリCBX1000FCR
タグCBX1000FCRFCR-Beginners
FCR

FCR Tuning - Where should I tune the main jet at full throttle?...

This is about the main jet settings for the CBX1000. You may not need to worry about this too much on a small motorcycle, but where should you set the main jet on a large motorcycle? There is only one answer. [Chassis dynamo] Nowhere else to do it other than on the chassis dynamo. You can sign a contract for about 200,000 yen per month.
       
カテゴリCBX1000FCR
タグCBX1000ColumnFCRFCR-BeginnersMJ
FCR

Selecting a jet needle for the CBX1000 FCR model - I want to choose something other than the 90FXM...

The current CBX1000 FCR jet needle shipped by BITO is apparently 90FXM#3. I called to ask. The 90FXM has a special cut-out with an [X]. Normally it's [T]. I don't want to change the taper angle, but I'd like to change the straight diameter in various ways, but there are no options.
       
カテゴリCBX1000FCR
タグCBX1000ColumnFCRJN
Cowl

Riding is fun when you attach a cowl to a naked motorcycle...

Driving review with CBX400F Integra cowl installed on CBX1000. I am not talking about how easy it is to drive without the wind,or how it looks,but it is a lot of fun to throw it around and knock it over. My riding technique is rather poor. And if anything,it feels like a straight line number.
       
カテゴリCBX1000Cowl
タグCBX1000ColumnCustom
FCR

FCR Settings - How to adjust the AS air screw and PS pilot screw...

I will write about my own method of adjusting the FCR screw for the CBX1000 FCR setting. There may be better ways, but this may be useful for CBX1000 owners who are just starting to set up their FCR. In my opinion, adjusting and synchronizing the screws on a 6-cylinder engine is more of a hassle than it is difficult.
       
カテゴリCBX1000FCR
タグASCBX1000FCRFCR-BeginnersPS
FCR

Does the CBX1000 require an FCR accelerator pump?...

I'm writing about whether the CBX1000 needs an FCR acceleration pump. I want to make effective use of what I can use. Keihin also uses this mechanism because it is necessary. It is said that single engines such as the SR have too much total discharge. I think that the timing of the start of discharge should be decided more strictly than the total discharge amount.
       
カテゴリCBX1000FCR
タグAccelerationPumpCBX1000ColumnFCR
Cowl

Frame mount cowl installation cost - for CBX400F Integra installation...

I saw a cowl for the CB750F being put up for sale,as well as a cowl that was attached to the CBX1000. Just buying it is not the end,so please use it as a reference for what you need and what to do after you buy it. Frame-mounted cowls are not just a DIY job that you can install after purchasing them.
       
カテゴリCBX1000Cowl
タグCBX1000CBX400FRepaint
FCR

FCR Tuning - Throttle opening 1/16 determined by straight diameter and slow jet...

This is a story about when I used a jet needle that I bought a few years ago for setting the FCR of my CBX1000 but hardly used. The other day, I looked back at the past logs about the changes in the straight diameter of the SJ and JN. My experience is different from that of my past self, so the accuracy and precision of what I have written down will be different.
       
カテゴリCBX1000FCR
タグASCBX1000FCRFCR-BeginnersJNPSSJ
FCR

FCR lifespan. It was fine even after 20 years of use....

Recently,I've been writing more about FCRs,but I haven't been able to touch or ride a motorcycle. This time,I'll write in a column-like format,but I'll also briefly talk about the lifespan of FCRs,which many of you are curious about. As the title says,my CBX1000 has had an FCR installed for over 20 years.
       
カテゴリCBX1000FCR
タグCBX1000FCR