2023-12

FCR

FCR Tuning - Should the Slow Jet Be Changed According to the Season?...

Tuning the FCR requires adjustments based on the weight of air and fuel. As the temperature drops, the density of the air increases, making the air heavier. In response, it is necessary to either increase the weight (amount) of the fuel or reduce the amount of air.
       
カテゴリCBX1000FCR
タグASCBX1000ColumnFCRFCR-BeginnersJNPSSJ
FCR

FCR Tuning - To What Extent Should Carburetor Synchronization Be Done?...

How Far Should Carburetor Synchronization Be Done?When performing synchronization using a vacuum gauge, there are graduations to consider.Is it acceptable for the reading to be off by one graduation?Does even the width of the black line on the gauge count as an error?There are many questions. Recently, I was able to hear the answer from the legend, Mr. Bito.
       
カテゴリCBX1000FCRMaintenance
タグCBX1000ColumnFCRFCR-BeginnersVacuumgauge
FCR

With the FCR, you can start the engine even on early winter mornings....

I will write about starting the engine of a motorcycle with a carburetor in the early winter mornings. Logically speaking, the Honda Cub, which was commonly used for newspaper delivery in the past, starts the engine easily with the choke and kick start, even on cold winter mornings. Now, regarding motorcycles equipped with FCR carburetors, they don’t have a choke, but you can use the accelerator pump as a substitute. By twisting the throttle about three times and then waiting for about 10 seconds before turning on the starter motor, the engine starts up normally.
       
カテゴリCBX1000FCR
タグCBX1000ColumnFCR
Maintenance

re the standard brakes of classic motorcycles low in performance? I customized my brakes....

Comparison of brakes from the past and present: Even when comparing a CBX1000 equipped with a recently manufactured complete brake system to a CBX1000 that is using well-maintained, 40-year-old brakes, the performance difference is significant.
       
カテゴリCBX1000Maintenance
タグBremboCB-FCBX1000CNCColumnCustom
FCR

For FCR Beginners - Don’t use the red Velocity Stack on the street as it is!...

When you purchase an FCR, it comes with a red Velocity Stack. It’s a 30mm red plastic Velocity Stack. The Velocity Stack of the FCR can be considered the 'exhaust' on the intake side. It is an essential part for smoothing the airflow.
       
カテゴリCBX1000FCR
タグCBX1000ColumnFCRFCR-BeginnersRamair
FCR

FCR Tuning - When changing the straight diameter of the jet needle, also adjust the clip position....

When you change the straight diameter of the jet needle, you may need to change the clip position as well, or else the performance can become quite poor. It’s difficult to specify exactly how many steps you should change the straight diameter before adjusting the clip position, but it seems reasonable to think that changing the straight diameter by about five steps would correspond to a change of approximately one clip position.
       
カテゴリCBX1000FCR
タグCBX1000ColumnFCRFCR-BeginnersJN